Seal the end of every drip tape lateral cleanly and securely with these Rivulis drip tape end plugs. A proper end closure is essential to maintain system pressure along the full length of each run — without it, water will escape at the tail end rather than being delivered evenly through the emitters where it’s needed.
These end plugs use a simple fold-and-tuck design — no tools required. They’re quick to install and quick to remove, making system flushes and end-of-season tape retrieval straightforward. Compatible with standard 16mm (5/8″) Rivulis T-Tape, Ro-Drip, and all major brands of drip tape.
Key features
- Seals the end of drip tape laterals to maintain correct system pressure throughout each run
- Fold-and-tuck design — installs and removes by hand in seconds, no tools needed
- Durable hard plastic construction — resists cracking in field conditions
- Reusable season after season
- Compatible with 16mm (5/8″) Rivulis T-Tape, Ro-Drip, and all major drip tape brands
- Easy to remove for end-of-season flushing before tape retrieval
How to install
- Feed the end of the drip tape through the narrow opening of the plug
- Leave approximately 75mm (3 inches) extending past the wider opening
- Fold the extended tape back on itself two or three times
- Tuck the folded section back into the wider end of the plug
- Slide the plug up to the end of the tape — the fold creates a secure, pressure-tight seal
To flush the system, simply remove the end plug, allow water and debris to purge, then refit before shutting down.
